Some problems sometimes appear in the process of using the spray gun. Now we will analyze the phenomenon of the spray gun in detail, and according to the phenomenon, analyze the reasons and find out the solutions.
Here are some common faults and solutions:
| fault | reason | solutions |
| Left or right | 1.The fan control hole on one side of the air cap is blocked | Clean the atomizing cap |
|
Replace the atomizing cap | |
| The center of spraying amplitude is too thick |
|
Reduce paint viscosity |
|
Increase spray pressure | |
|
Replace nozzle set | |
| Spray amplitude splitting | 1.Paint viscosity is too low | Increase paint viscosity |
| 2.Spraying pressure is too high | Reduce the spraying pressure | |
| 3.The inner diameter of the fan control hole is too large | Replace nozzle set | |
|
Add enough paint | |
|
Clean the air passage of the spray gun | |
| Jump gun | 1.The nozzle is not tightened or installed properly | Tighten the nozzle or clean and install the nozzle set |
| 2.Loose gun needle seal kit | Fastening thimble seal kit | |
| 3.The connecting nut of the spray gun is loose (lower pot spray gun) | Tighten the connecting nut | |
| 4.Insufficient paint in the pot | Supplementary coating | |
| 5.Nozzle set damaged | Replace nozzle set |
Post time: Jul-25-2022